Researchers in India build $380 immersion cooling testbed that holds 500 W heater at 118.3 C
A preprint reports a $380 open-source immersion cooling testbed that managed a 500 W heater load in mineral oil. The system kept the heater at 118.3 C and the oil only 8 C above ambient, with most thermal resistance at the heater-oil interface. It matters because cooling costs and component temperatures are direct concerns for data centers and high-performance computing, though the evidence is limited to a prototype.
A preprint by Pramukto Mandal describes a single-phase immersion cooling testbed for liquid cooling of data center hardware, using a 500-watt titanium heater as a stand-in for a server load. The heater was submerged in a glass tank of mineral oil, a dielectric fluid, and circulated by a magnetic-drive pump through an air-cooled radiator. An ESP32 microcontroller logged temperature sensors and controlled the pump, fan and heater through a relay module.
At quasi-steady state under the full 500-watt load, the heater surface reached 118.3 degrees Celsius, while the bulk oil stayed at 29.3 degrees Celsius, only 8.0 degrees above ambient. Thermal-resistance analysis attributed about 92 percent of total resistance to the heater-to-oil interface, limited by natural convection, at 178.0 millidegrees Celsius per watt versus 16.0 for the external loop. The authors report the complete system cost 35,318 Indian rupees, about 380 U.S. dollars.
The result is a methods note: the study is a single experimental testbed, not a controlled comparison across commercial servers, and it uses a heater rather than computing hardware. Immersion cooling matters because air cooling can struggle with dense electronics, and dielectric fluids can move heat directly from components. The authors' open CAD files, firmware and data make the setup reproducible for comparing fluids, loads and flow arrangements, but the 92 percent interface bottleneck shows the hardest heat transfer step remains near the component surface.
For data centers, and for high-performance computers and gaming rigs that generate dense heat, cooling is a direct cost and reliability issue. A cheaper, transparent testbed lets engineers and hobbyists test whether mineral oil, flow rates or radiator designs can improve heat removal at low cost. The paper does not show lower electricity bills or longer hardware life for real machines; it shows a prototype can remove a known heat load with inexpensive parts and leave headroom in the external loop.
It affects anyone running dense electronics, including data centers and gaming PCs, because better cooling can lower energy use and keep hardware within safer temperatures, but this prototype has not yet tested real computers.
Sources (1)
- [1]Design and Experimental Evaluation of a Low-Cost Immersion Cooling System(https://arxiv.org/abs/2611.17361)